What is the role of the temperature sensor?
As soon as the temperature drops below 5° C (40° F), the temperature sensor shuts off the main water supply and a sound signal is [...]
Is it possible to install the system in a well that is equipped with a water pump?
Yes. The 10 Amps and 30 Amps breakers were specially designed to turn off the water supply of wells equipped with water pumps up.
Can the system inform us in our absence if there is a water leak detection?
The system can be connected to your alarm system. Simply add a new zone to your alarm system and connect it to the master module [...]
What is the lifespan of a battery?
A battery can last up to ten years. Our system has its own shared autonomy technology, which means that the detectors consume no energy as [...]
Is there a signal when the batteries are low?
The system was designed with low battery check. When a low battery is detected, the system will fall into trouble mode, indicating which sensor is [...]
There’s no power outlet near the valve, what should I do?
You can add a length of electric wire of the same type to connect the master module to the valve. Please contact us for more [...]
What happens in case of a power outage?
The emergency battery will turn on for approximately 24 hours. If the power outage persists, the system automatically shuts down and turns off the water [...]
How long will the valve stay closed once a water leak is detected?
To turn the water supply back on, you must reset your system. The tracking signal will persist until the master module is reset.
Is it possible to use the valves for hot water?
The valves work just as well with both hot and cold water.
Is it possible to connect more than one valve to the master module?
The master module has been designed to accommodate up to three additional valves.